Page 1 of 1

Can't update the firmware

Posted: January 21st, 2021, 11:57 am
by sbaliko
Hi!

I had a few issues in the past, so I eagerly waited the updates. However, in the Unleashed app, the firmware page still says 1.45 is the latest update. Nikon D750 and Samsung Galaxy S10+.

Thank you:
Sándor

Re: Can't update the firmware

Posted: January 22nd, 2021, 6:30 pm
by Oliver
Hi Sándor

There are hardly any relevant changes in the latest updates, which is why we never updated the Android app with the latest firmware.
however if you really want to try, you can do the update using an iPhone or iPad (maybe you can ask a friend with an iPhone), run the update, and then continue using the Android phone.

See the few changes we did make here:
https://www.foolography.com/products/un ... /firmware/

Re: Can't update the firmware

Posted: February 1st, 2021, 3:32 pm
by sbaliko
Hi Oliver!

Thanks for your reply! The reason I'm following the firmware updates, because my unit (N2 with a Nikon D750) just not working every time. Sunset or sunrise, it's not following the light conditions, every settings just stay at the level of the beginning. 70% of the time it's just working perfectly, but when it's not, its annoy me. Unplugging and plugging back mostly works, but not always.

Thank you:
Sándor
Oliver wrote:
January 22nd, 2021, 6:30 pm
There are hardly any relevant changes in the latest updates, which is why we never updated the Android app with the latest firmware.
however if you really want to try, you can do the update using an iPhone or iPad (maybe you can ask a friend with an iPhone), run the update, and then continue using the Android phone.

Re: Can't update the firmware

Posted: February 1st, 2021, 3:50 pm
by Andy
Hi Sándor,

good news is that the beta firmware is looking solid and we should be able to release a new version soonish. We will probably update a new beta this week, and if everything goes well, we will then release the FW ASAP.

Thank you for your patience! :)

Re: Can't update the firmware

Posted: February 1st, 2021, 6:56 pm
by sbaliko
No pressure, thank you! :)